- Active tracking (data logging and tracking of vehicle position and status of sensors and alarm sensors) - Listening and voice communication - Alarm and event messaging - Output control over GSM/GPRS data channels - System management, configuration and firmware update over GSM/GPRS data channels System idenficator; NMEA GGA and RMC including date, time, latitude, longitude, the information about satellites and signal quality; unique number of record, the status of digital and analogue input signals, relay outputs, alarm zones; system run and reloading flag. Supported modes: periodical and event-based. Over speeding; Temperature exceeded; No-go zone entered; GSM status (search, local or roam); GPS malfunction, illegal position; input call or SMS message; timer. GSM SMS, CSD, GPRS Serial RS232 connectiovity or external Bluetooth, IrDA or radio adapter. Linking modes: periodic and event-based; selfrecofering link mode supported. Periodic relay output control and control upon custom-selected event.
This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.
Use Plaspy with a tracker
Set the Operator APN
Check your tracker clock setup is set UTC-0 o GMT. (The most trackers come from the factory on UTC.)
For most devices you should use IMEI (International Mobile Equipment Identity) number as unique identifier. However, some devices have vendor specific unique identifier, for example TK-103 devices use 11-digit identifier.
Set Up the Plaspy's IP and port on your tracker: (Plaspy detects tracker's protocol.)
Add a Plaspy Account on devices with the IMEI or unique ID.