Menu
Locate and manage all your devices in one place.

TZone - TZ-AVL05

 
From $0.99 USD*
       
Pay as you go. No contract
TZ-AVL05
Visit the manufacturer website

Description:
·Track by software/by cell phone.     

·Over-speed alarm, Low power alarm, Geo-fence alarm.        

·Roaming feature to save cost.       

·Control or detect the car doors/engine on/off .      

·Cut off the  engine power Gradually and safely when in urgency.      

·GPRS(TCP/UDP), SMS Support.     

·OTA, upgrade the firmware via GPRS.       

·Backup battery,  Send a data every minute,support 12 hours working time.

Special Features:       
·Support commands to device via GPRS.       
·SMS Link for google map.       
·Sending GPRS data to IP or DNS.       
·Mileage calculation.       
·32Mb Flash Memory.       
·Fuel/oil level detection.        
·Temperature sensors(optional) .       
·With Microphone and listen-in function(Two-way conversation).

·Support ibutton.

Specifications:  
Dimension
96mm*65mm*25mm
N.W
0.24KG
Exterior Power Supply
DC9V-36V
Inner Lithium battery
DC 3.7V-4.2V
Exterior GSM antenna
Receive GSM Signal better
Exterior GPS antenna
Receive GPS signal better
Power Consumption 
Active mode(avg.)<100mA
when exterior voltage is 12V
Sleep mode <5mA
Operating Temperature Range
-20 °C to +60°C
Humidity
Up to 75% non-condensing
position accuracy
10-15metres
GSM chip
support Quad-band(850/900/1800/1900 Mhz)
GPS chip
super sensitivity and high accuracy
LED
3LEDs indicate power, GSM, GPS signal, and trembling status( 2 Changer Light )
Microphone
yes
Hot start
1 sec., average
Warm start
38 sec., average
Cold start
42 sec., average
I/O port 
4 digital inputs (2 negative  inputs, 2  positivel inputs ), 2 digital outputs, 2 analog inputs

Configuración TZ-AVL05

Country Operator APN User Password

To set Plaspy you need to configure as follows. With the following commands through several text messages: In the example it is assumed that the device password is 000000 which is the initial data from the device and the APN are to APN_OPERATOR

  1. Set up our operator APN
    9YUyHncJsUxsq1lyQxxhxPFH5GVS07ldmGspaX
  2. Define how often will transmit to our example 120 seconds
    264gR2JNzXjBRkxm0n8W
  3. Establish the server where we will connect
    03AfW54FtvQjWy1vduSN3ARKSusTGjI6X
  4. Activate the GPRS mode
    Nd0l0MlNk8KnUL

 


This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.