Description: ·Support single location and continual tracking
·Over-speed alarm, Low power alarm, Geo-fence alarm
·Tremble alarm, Parking alarm, SOS alarm
·Control car doors close/open, detect the status of engine on/off
·Cut off the engine power gradually and safely when in urgency
·GPRS(TCP/UDP), SMS Support
·When without tremble the device will go into sleep mode
1.SD card record (optional) .
2.Can connect external RFID Reader, Cameras, Printer (optional).
4.Support sending GPRS data to IP or DNS.
6.32Mb flash memory.
7.Fuel/oil level detection .
8.Temperature sensors (optional) .
9.Two- way conversation.
10.Mobile Google map.
N.W for machine
Exterior GSM antenna
Receive GSM Signal better
Exterior GPS antenna
Receive GPS signal better
Exterior RF antenna
Receive RF signal better
Operating Temperature Range
-20℃ to +60℃
Up to 75% non-condensing
Within 10m for 90% (24hr static, -130dBm)
Support Quad-band(850/900/1800/1900 Mhz)
Super sensitivity and high accuracy
Chipset Cold Start (open sky)
Chipset Warm Start (open sky)
Chipset Hot Start (open sky)
3 LEDs indicate power, GSM, GPS signal, and trembling status
Microphone & speakers
2 analog input ports, 6 digital input ports(2 positive input, 4 negative input), 3 digital output ports, 4 serial ports and 1 mini USB port
To set Plaspy you need to configure as follows. With the following commands through several text messages: In the example it is assumed that the device password is 000000 which is the initial data from the device and the APN are to APN_OPERATOR
Set up our operator APN ukFh53GhQbiNk0YP5L0tHAUxV4Y9Z7qrstXxEn
Define how often will transmit to our example 120 seconds R87qe0z2KSaVAhU6QEnh
Establish the server where we will connect M2CmJf4Ll7nYZVubouPSMBeHITv1e1clL