Menu
Locate and manage all your devices in one place.

TZone - TZ-AVL10

 
From $0.99 USD*
       
Pay as you go. No contract
TZ-AVL10
Visit the manufacturer website

Description:

·Long standby time

·Track by software/by cell phone

·Over-speed alarm, Low power alarm, Geo-fence alarm

·Roaming feature to save cost

·Control or detect the car doors/engine on/off

·Cut off the  engine power Gradually and safely when in urgency

·GPRS(TCP/UDP), SMS Support

·OTA, upgrade the firmware via GPRS


Special Features:

·Long time standby more than three months

·Support commands to device via GPRS

·SMS Link for google map

·Sending GPRS data to IP or DNS

·32Mb Flash Memory

·Fuel/oil level detection

·Temperature sensors

·With Microphone and listen-in function

·button A can to dial the specified phone

Specifications:  
Feature
Characteristics
Dimension
122mm*81mm*30.8mm
Exterior Power Supply
DC 9V -- 36V
USB charge
5V
Inner lithium battery
DC 3.6V -- 4.2V/4500mah
the Built-in GSM antenna
Receive GSM Signal better
the Built-in GPS antenna
Receive GPS signal better
Power Consumption when exterior voltage is 12V
Active mode(avg.) < 50mA         Sleep mode      < 5mA
Charging time
About 6 hours can be full
Standby Time
More than 3 months
Air pressure
860Kpa --1060Kpa
Humidity
Up to 75% non-condensing
Position accuracy
10 --15 meters
GSM chip
( 4 Frequency GSM 850/ 900/1800 /1900MHZ is optional)
GPS chip
(super-sensitivity and high accuracy )
LED
3 LEDs indicates GSM signal, GPS signal, and change
Button
2 buttons, SOS button and button A

 

Configuración TZ-AVL10

Country Operator APN User Password

To set Plaspy you need to configure as follows. With the following commands through several text messages: In the example it is assumed that the device password is 000000 which is the initial data from the device and the APN are to APN_OPERATOR

  1. Set up our operator APN
    JUYsppmOnPD6vpvAyNNMCIpaTnP0PdfpuiMd1Z
  2. Define how often will transmit to our example 120 seconds
    ZHN8C6Fc7sirM2XQQmMy
  3. Establish the server where we will connect
    FAN9Mk8W5rJCkIZd5Ap7YCav9KuXLNcRJ
  4. Activate the GPRS mode
    3ADkcAC0kKsO13

 


This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.