TLT-1D Remote Control Vehicle GPS Tracker is a location tracking device based on GPS technology and GSM/GPRS technology, you can have the latitude and longitude through cell phone message to locate the tracker in Google Maps or other mapping software; or data uploaded through GPRS to the specified server, you can also search the real-time and historical track on the internet.
TLT-1D Remote Control Vehicle GPS Tracker applies to vehicle, motorcycle, electric golf cart, private car etc.
You can open and close the door with the remote control.
1.Built-in high-performance (U-BLOX) GPS chipset enables the product to provide accurate positioning with weak signal and to work normally in urban area, valley or other sight-limited districts.
2.Built-in GSM/GPRS module supports GSM900/1800MHz (850/1900 MHz), it can work throughout the world.
3.It supports SMS communications or GPRS TCP connection and receive position information through cell phone message or look into track on the internet.
4.It provides such functions as SOS, fuel cutoff/power failure(optional), warning by cutting off external power wire, geo-fence, overspeed warning, historical data upload, parking throttle upload and moving car tracking timing upload.
5.It provides voice call function.
6.It is equipped with highly reliable electric circuit and complies with electronic industry standards.
1. SMS(Mobile Phone) and GPRS TCP/UDP Communication(Tracking Platform)
2.Track on Demand and Time Interval
3.Show Location Information on Mobile Phone/Tracking Platform (Speed,Date,Time,Longitude&Latitude)
4.Two-way Communication/Listening-In Function (Earphone Required)
5.GSM Blind Area Memory
6.Built-in Motion Sensor for Power Saving
7. Emergency Alarm
8. Movement Alarm
9. Geo-Fence Function
10. Low Battery Alarm
11. Towing Alarm
12. Speeding Alarm
13. GPS Blind Area Alarm
14. ACC Detection Function
15. Power-Cut Alarm
16. Engine Stop Function
17. Mileage Statistics
18. Power/Fuel Cut Off (Relay Required)
19. Open and Close the Door
To set Y6UEdm you need to configure as follows. With the following commands through several text messages: In the example it is assumed that the device password is 0000 which is the initial data from the device and the APN are to APN_OPERATOR
Factory reset NjZCQeOkAfBjE
Set up our operator APN BnfbAOC486ez2JGzRP4h64xrK4JLXMRmjjBUC
Establish the server where we will connect HGxNET9d7grLzZnV43GzxRFE0hwo2Q
Define how often will transmit to our example 120 seconds THwwJJGT2lyOMXbAi wnRpq5eO0AsWhgUlr