NVS - SN-5001

A compact navigation device that allows you to determine the current location by the signals of the satellite systems GLONASS and GPS, as well as transmit this information to the monitoring center (CM), receive data from the CM, settings. The device is able to receive incoming and outgoing phone calls to the programmed numbers, as well as to send an alarm signal to the CM from the user.
This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.

Set Up SN-5001


To set ainRRm you need to configure as follows. With the following commands through several text messages: In the example it is assumed that the device password is 123456 which is the initial data from the device

  1. Factory reset
  2. Set the time zone UTC-0
    Kn2E dS6XsX5rMh G
  3. Set up our operator APN
    53paLrc7Z ArU3UTA
  4. Set the username and password of APN operator
    REK2MXVY fpKz5xDl lXe4N5H8
  5. Establish the server where we will connect
    gEIvOOL6kNvWa TTOE502S3MDS6 RyON
  6. Switch to GPRS mode to begin transmission UDP

To check settings pdEv7DDYXku