Loading...

Jointech - GP 5000

GPS tracker for real time tracking, fuel level montoring, fleet management

System features: 
SMS, GPRS TCP/UDP communication
Fuel consumption monitor
14-channel vehicle signal alarm
Blind area data re-report
Supports 360-point blind area data and 21, 600 pieces history data
Data transmitted unvarnished
Remote control fuel and power break
Initiative anti-theft
Remote configuration
Real-time tracking (time, distance interval or intelligent mode)
Intelligent power management
Power low/lost alarm, backup battery low alarm
16 geo-fencing reports
Journey report wireless download
GPS mileage report/electronic mileage report
GPS antenna disconnect/cut/short circuit alarm
Up to 120, 000 data log storage
Hardware specifications: 
Dimension: 121 x 82 x 29mm
Weight: 0.85kg
GPS receiver: 20-channel or above GPS receiver
Datum: WGS-84
Power source: 10 to 33V DC
Power consumption: Less than 100mA at 12V DC in operating mode
Operating temperature: -40 to +85
Communication: GSM 850/900/1800/1900MHz
Serial port: 3 RS-232 serial ports

Programmable input port: 
Input: 14-channel
Port A: Power and vehicle control
Port B: Detecting 14-channel vehicle signal
Port C: Connect to additional peripheral, such as RFID, scanner, sensor
Output: 8-channel
Buffer memory: 128KB
Built-in memory: 2MB
Default baud rate: 9, 600BPS
Backup battery: 350mAh
Peripherals: Supports at most 2 additional peripherals at the same time
This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.

Set Up GP 5000

Country
Operator
APN
User
Password

To set a Jointech device on VPTTjE are configured through text messages, it is necessary to confirm these commands with user manual, then you need to configure as follows.

With the following commands through several text messages: In the example it is assumed that the device is trackerID XXXXXXXXXX which is the initial data from the device and the APN are your operator

The most common commands for these enabled devices are placed (You should consult your manual).

  1. Set the server where we will transmit and APN our operator, values Replace your operator
    LdxsuHJl0FEhgsEGP4Ex69q8qweGUD63o85bufU2WkWNxwZViJ6
  2. This command is only required if your service provider requires a username and password, APN settings. Replace the values of your operator
    n1QzLwzC8nCQxIL3hwmVtjLbWncK4WJiKHSBYJtp5d