Loading...

istartek - VT600-3G

Specification:

Items Specifications
Power Supply 10.6V - 36V / 1.5A
Backup Battery 500mAh
Normal power consumption 55mA/h
Dimension 65mm x 61mm x 26mm
Weight 90g
Work time 30 hours in power-saving mode and 7.5 hours in normal mode
Operating temperature -20 to 65 Degree
Humidity 5% to 95% Non-condensing
Frequency
 VT600 3G-T 
UMTS/HSDPA: 850/2100MHz
GSM/GPRS: 850/900/1800/1900MHz
VT600 3G-A
UMTS/HSDPA: 850/1900MHz
GSM/GPRS: 850/900/1800/1900MHz
VT600 3G-E
UMTS/HSDPA: 900/2100MHz
GSM/GPRS: 900/1800MHz 
GPS Module latest GPS SIRF-Star IV chipset
GPS Sensitivity -159Db
GPS Frequency L1, 1575.42 MHz
C/A Code 1.023 MHz chip rate
Channels 20 channel all-in-view tracking
Position Accuracy 10 meters, 2D RMS
Velocity Accuracy 0.1 m/s
Time Accuracy 1 us synchronized to GPS time
Default datum WGS-84
Reacquisition 0.1 sec., average
Hot start 1 sec., average
Warm start 38 sec., average
Cold start 42 sec., average
Altitude Limit 18,000 meters (60,000 feet) max
Velocity Limit 515 meters/second (1000 knots) max
LED 2 LED lights to show GPS/GSM status
Flash Memory 8MB
Button One SOS Button
Interface 3 digital inputs (1 negative, 1 positive triggering and 1 input changeable)
1 analog input
1 output.

 

Standard Accessories:

VT600 3G Tracker GSM Antenna GPS Antena

 Power Cable

 

 Optional Accessories:

USB Data Cable Fuel Sensor Microphone Pin Switch     Relay  iButton Buzzer Temp. Sensor

This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.

Set Up VT600-3G

Country
Carrier
APN
User
Password

To set the tracker send the following commands by SMS messages

  1. Reset factory settings
    FACTORY#
  2. Set the time zone UTC-0
    GMT,E,0#
  3. Set the operator APN
    APN,{{apn}},{{apnu}},{{apnp}}#
  4. Set the GPRS server
    SERVER,1,d.plaspy.com,8888#
    or
    MCmWcrjPidpgG0QpexL0pgP2uiNf
  5. Set the update interval every 60 seconds
    TIMER,60#

To check parameter settings PARAM#