Start Your FreeMonth
From $0.99 USD*
Pay as you go. No contract
The LMU-3200 is an ideal solution for automotive insurance, driver behavior management, auto rental and automotive applications when access to the vehicle diagnostics interface (ODB-II) is required.
The LMU-3200 full featured tracking unit from CalAmp features a small size, superior GPS design, ODB-II interface, and 3-axis accelerometer. These features enable the LMU-3200 to access vehicle diagnostic interface data, track vehicle speed and location, plus detect hard braking, cornering or acceleration. Superior internal antennas for both cellular and GPS eliminate the need for professional installation and make the LMU-3200 install quick, easy and inexpensive. Messages are transported across the cellular network using enhanced SMS or UDP messaging providing a reliable communications link between the device and your application servers. The LMU-3200 is designed to dramatically reduce cost, power and size while significantly improving field reliability in 12 volt passenger or light-duty vehicles.
The LMU-3200 employs CalAmp’s advanced industry leading on-board alert engine, (PEG™) (Programmable Event Generator) to monitor external conditions and support customer-defined exception-based rules to meet your application requirements. PEG monitors the vehicle environment ans responds instantaneously to pre-defined threshold combinations related to time, date, motion, location geozone, input and other event combinations. This behavior can be programmed by CalAmp before shipment, at a customers facility, or over-the-air once the unit has been fielded.
The LMU-3200 leverages CalAmp’s management and maintenance system, PULS™ (Programming, Updates, and Logistics System), for over-the-air configuration parameters, PEG rules and firmware. This out-of-the-box hands free configuration and automatic post-installation upgrades can monitor unit health status across your customers’ fleets to identify issues before they become expensive problems.
To set n5mdbL you need to configure as follows. With the following commands through several text messages, the ID is the MID 10 digits replied by 4Oh command
- Set up our operator APN
- Set the username and password of APN operator
- Establish the server where we will connect
- Reset device
To check the settings Yg8