Working Based on existing GSM/GPRS network (850/900/1800/1900Mhz) and GPS satellites, this product can locate and monitor any remote targets by SMS or internet.
Function:
- Change Password
- Authorization
- Single Locating
- Auto track continuously
- Automatic update positions of vehicle turns
- GPS drift suppression
- Absolute street address by SMS
- Location based service (LBS)
- Voice Monitor -Data logging
- Data Load
- Forward the third parties’ message
- Charges Inquiry
- Alarm Function
- Low battery alarm
- External Power off alarm (Suitable for B, C and D model)
- GPS blind Spot alert
- SOS
- Geo-fence
- Multi-area management
- Movement alarm
- Over speed alarm
- ACC working alarm (Option, for model B, C, D)
- Fuel alarm (Option, for model C, D)
- Cut off the Oil and Power System (Option, for model C, D)
- Arm
- Silent Mode
- DISARM
- Door alarm (Option for model C and D)
- ACC alarm (Optional for model B,C,D )
- Shock Sensor alarm
- Alarm without GSM network service
- Check the Vehicle State
- Reset Hardware
- Sleep Mode
- Sleep by time
- Sleep by shock sensor
- No sleep mode
- Set up Terminal (local) Time
- TCP / UDP Switch
- Configure parameters by USB
- GPRS setting
- Setting up APN
- GPRS User ID and password Setup
- IP and port setup
- Less GPRS traffic
- Modes Switch between “SMS” and “GPRS”
- Set up monitor center number
This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.
Set Up GPS303
Country
Carrier
APN
User
Password
To set the tracker send the following commands by SMS messages, the sample setup the device password is 9Ai0Yc, this password is the default
- Factory reset
begin9Ai0Yc - Set the time zone UTC-0
time zone9Ai0Yc 0 - Set the operator APN
apn9Ai0Yc {{apn}} - Set the username and password of APN operator
up9Ai0Yc {{apnu}} {{apnp}} - Set the GPRS Server
adminip9Ai0Yc 54.85.159.138 8888 - Set update interval
fix060s060s***n9Ai0Yc - Switch to GPRS mode to UDP or TCP
m1ziQMvSGQ,1,1
or
m1ziQMvSGQ
To check settings check9Ai0Yc
To enable the status of the fuel sensor or improve the transmission of the status of the digital sensors protocol9Ai0Yc 18