Coban - GPS306

Visit the manufacturer website

Working Based on existing GSM/GPRS network (850/900/1800/1900Mhz) and GPS satellites, this product can locate and monitor any remote targets by SMS or internet.

Function:

Change Password
Authorization
Single Locating
Auto track continuously
Automatic update positions of vehicle turns
GPS drift suppression
Absolute street address by SMS
Location based service (LBS)
Voice Monitor -Data logging
Data Load
Forward the third parties’ message
Charges Inquiry
mainteanance remind alert
Low battery alarm
External Power off alarm
GPS blind Spot alert
Geo-fence
Multi-area management
Movement alarm
Over speed alarm
Alarm without GSM network service
Check the Vehicle State
Reset Hardware
Sleep Mode
Sleep by time
Sleep by shock sensor
No sleep mode
Set up Terminal (local) Time
TCP / UDP Switch
GPRS setting
Setting up APN
GPRS User ID and password Setup
IP and port setup
Less GPRS traffic
Modes Switch between “SMS” and “GPRS”
Set up monitor center number

This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.

Set Up GPS306

Country

Operator

APN

User

Password

To set f2JG0x you need to configure as follows. With the following commands through several text messages: In the example it is assumed that the device password is 123456 which is the initial setting from the device

Factory reset
gkGxm5GEs27
Set the time zone UTC-0
SIHU 3WrkSk4Rit u
Set up our operator APN
sBI00Yb9u J7mK9Lw
Set the username and password of APN operator
fn47K6YV 8XRQL65l y74DzMRb
Establish the server where we will connect
TxYbyzeiMZ5cr 5padyOqsKqEib I4Pm
Switch to GPRS mode to begin transmission UDP
FNMBrWbD0IWK6t
or
wKF54Yz3d3

To check settings qOKqdYsf4h7

To enable the status of the fuel sensor or improve the transmission of the status of the digital sensors SWcpCzEcmqr7kC oC

Atrás


Start Your FreeMonth		From $0.99 USD*		Pay as you go. No contract