Loading...

Coban - GPS403

Detailed description:

Working Based on existing GSM/GPRS network (850/900/1800/1900Mhz) / WCDMA (3G): 850/1900/2100/Mhz and GPS satellites, this product can locate and monitor any remote targets by SMS or internet.

 

Function:

  • Change Password
  • Authorization
  • Single Locating
  • Auto track continuously
  • Automatic update positions of vehicle turns
  • GPS drift suppression
  • Exact street address
  • Location based service (LBS)
  • Forward the third parties’ message
  • Charges Inquiry
  • Alarm Function
  • Low battery alarm
  • External Power off alarm 
  • GPS blind Spot alert
  • SOS
  • Geo-fence
  • Movement alarm
  • Over speed alarm
  • ACC working alarm 
  • Fuel alarm
  • Cut off the Oil and Power System
  • Arm
  • Silent Mode
  • DISARM
  • Door alarm 
  • ACC alarm 
  • Shock Sensor alarm
  • Alarm without GSM network service
  • Check the Vehicle State
  • Reset Hardware
  • Sleep
  • No sleep mode
  • Set up Terminal (local) Time
  • TCP / UDP Switch
  • Activate Fuel value in GPRS data
  • Configure parameters with TF card
  • GPRS setting
  • Modes Switch between “SMS” and “GPRS”
  • Set up monitor center number
  • Configure heartbeat package interval
This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.

Set Up GPS403

Country
Carrier
APN
User
Password

To set the tracker send the following commands by SMS messages, the sample setup the device password is 80RA0u, this password is the default

  1. Factory reset
    begin80RA0u
  2. Set the time zone UTC-0
    time zone80RA0u 0
  3. Set the operator APN
    apn80RA0u {{apn}}
  4. Set the username and password of APN operator
    up80RA0u {{apnu}} {{apnp}}
  5. Set the GPRS Server
    adminip80RA0u 54.85.159.138 8888
  6. Set update interval
    fix060s060s***n80RA0u
  7. Switch to GPRS mode to UDP or TCP
    e0NZt9hBgH,1,1
    or
    e0NZt9hBgH

To check settings check80RA0u

To enable the status of the fuel sensor or improve the transmission of the status of the digital sensors protocol80RA0u 18