Loading...

TZone - TZ-AVL09

Description:
·Support single location and continual tracking         
·Over-speed alarm, Low power alarm, Geo-fence alarm        
·Tremble alarm, Parking alarm, SOS alarm        
·Control car doors close/open, detect the status of engine on/off        
·Cut off the  engine power gradually and safely when in urgency        
·GPRS(TCP/UDP), SMS Support        
·When without tremble the device will go into sleep mode        

 Special Features:        
1.SD card record (optional) .       
2.Can connect external  RFID Reader, Cameras, Printer (optional).    

3.3D accelerometer.      
4.Support sending GPRS data to IP or DNS.   
5.Mileage calculation.       
6.32Mb flash memory.         
7.Fuel/oil level detection .        
8.Temperature sensors  (optional) .        
9.Two- way conversation.          
10.Mobile Google map.

11.Support ibutton.     

Specifications:  
Dimension 118mm*93mm*31mm
N.W for machine 0.26KG
External Voltage 9V -36V
Backup Battery 850mAh /3.7V
GPS Sensitivity  -163dBm
Exterior GSM antenna Receive GSM Signal better
Exterior GPS antenna Receive GPS signal better
Exterior RF antenna Receive RF signal better
Power Consumption Active mode<100mA
Operating Temperature Range -20℃ to +60℃
Humidity Up to 75% non-condensing
Position Accuracy Within 10m for 90%   (24hr static,   -130dBm)
GSM Frequency Support Quad-band(850/900/1800/1900 Mhz)
GPS Chipset Super sensitivity and high accuracy
Chipset Cold Start (open sky) 35sec
Chipset Warm Start (open sky) 35sec
Chipset Hot Start (open sky) 1sec
LED 3 LEDs indicate power, GSM, GPS signal, and trembling status
Microphone & speakers yes
Interfaces  2 analog input ports, 6 digital input ports(2 positive input, 4 negative input), 3 digital output ports, 4 serial ports and 1 mini USB port

 

This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.

Set Up TZ-AVL09

Country
Operator
APN
User
Password

To set Plaspy you need to configure as follows. With the following commands through several text messages: In the example it is assumed that the device password is 000000 which is the initial data from the device and the APN are to APN_OPERATOR

  1. Set up our operator APN
    SgVEFoZ5koHeZMHHW8PeHRCrWjjC2BprdivC3X
  2. Define how often will transmit to our example 120 seconds
    8xoG7hDOe5ILwm2NNcui
  3. Establish the server where we will connect
    KlXJu9d2na0GYxdPFAeosgFXCi8aB0aFO
  4. Activate the GPRS mode
    Ppof9GMAC1wAv2