Loading...

TZone - TZ-AVL10

Description:

·Long standby time

·Track by software/by cell phone

·Over-speed alarm, Low power alarm, Geo-fence alarm

·Roaming feature to save cost

·Control or detect the car doors/engine on/off

·Cut off the  engine power Gradually and safely when in urgency

·GPRS(TCP/UDP), SMS Support

·OTA, upgrade the firmware via GPRS


Special Features:

·Long time standby more than three months

·Support commands to device via GPRS

·SMS Link for google map

·Sending GPRS data to IP or DNS

·32Mb Flash Memory

·Fuel/oil level detection

·Temperature sensors

·With Microphone and listen-in function

·button A can to dial the specified phone

Specifications:  
Feature
Characteristics
Dimension
122mm*81mm*30.8mm
Exterior Power Supply
DC 9V -- 36V
USB charge
5V
Inner lithium battery
DC 3.6V -- 4.2V/4500mah
the Built-in GSM antenna
Receive GSM Signal better
the Built-in GPS antenna
Receive GPS signal better
Power Consumption when exterior voltage is 12V
Active mode(avg.) < 50mA         Sleep mode      < 5mA
Charging time
About 6 hours can be full
Standby Time
More than 3 months
Air pressure
860Kpa --1060Kpa
Humidity
Up to 75% non-condensing
Position accuracy
10 --15 meters
GSM chip
( 4 Frequency GSM 850/ 900/1800 /1900MHZ is optional)
GPS chip
(super-sensitivity and high accuracy )
LED
3 LEDs indicates GSM signal, GPS signal, and change
Button
2 buttons, SOS button and button A

 

This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.

Set Up TZ-AVL10

Country
Operator
APN
User
Password

To set Plaspy you need to configure as follows. With the following commands through several text messages: In the example it is assumed that the device password is 000000 which is the initial data from the device and the APN are to APN_OPERATOR

  1. Set up our operator APN
    PMsiZ8CCN35dT3xnnLbpzAe3cKmryPt3rXx2aF
  2. Define how often will transmit to our example 120 seconds
    iGhJjB1zrz2KQn7ANMiJ
  3. Establish the server where we will connect
    F4gQ9mEvUthhlw3dLOsyFOWUO8JCw5G5N
  4. Activate the GPRS mode
    m90hLBAdC8YnlU