TZone - TZ-AVL11

Visit the manufacturer website

Description:

Built-in 2.4G RFID receiver.
Built-in antenna and battery.
Support GPRS(TCP/UDP), SMS, tracked by software/cell phone.
Support mini USB port to update firmware.
Low power consumption.
With Microphone and listen-in function.
With 32Mbit memory, can store about 16000 PCS data.
With Temperature sensor and control or detect car door/engine on/off.
GPRS alarm function:Over-speed /Geo-fence /Low battery /Power Cut/Motion/SOS.
.

Specifications:

Feature	Characteristics
Dimension	122mm81mm30.8mm
Exterior Power Supply	DC 11V -- 36V
USB charge	5V
Inner lithium battery	DC 3.6V -- 4.2V/4500mh
Built-in GSM antenna	Receive GSM Signal better
Built-in GPS antenna	Receive GPS signal better
Power Consumption when exterior voltage is 12V	Active mode(avg.) < 50mA Sleep mode < 5mA
Charging time	About 6 hours can be full
Air pressure	860Kpa --1060Kpa
Humidity	Up to 75% non-condensing
Position accuracy	10 --15 meters
GSM chip	SIMCOM, 4 Frequency GSM 850/ 900/1800 /1900MHZ is optional)
GPS chip	Super-sensitivity and high accuracy
LED	3 LEDs indicates GSM signal, GPS signal, and change

This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.

Set Up TZ-AVL11

Country

Carrier

APN

User

Password

To set the tracker send the following commands by SMS messages

Set the operator APN
*000000,011,{{apn}},{{apnu}},{{apnp}}#
Set the update interval 60 seconds
*000000,018,60,999#
Set the GPRS server
*000000,015,0,54.85.159.138,8888#
Activate the GPRS mode
*000000,016,1#

Trackers