MSP500 is a special tracking terminal with GNSS/GSM/Bluetooth connectivity, internal GNSS/GSM antennas, RS232 interface and internal Ni-Mh battery. Device was designed for speed limiting control.
Moreover, device contains integrated buzzer and relay for a speed limiting functionality based on a fuel pump power supply switching or accelerator pedal control using additional electronic throttle controller.
|Scenarios||Green Driving, Over Speeding detection with relay control, Jamming detection, GNSS Fuel Counter, Excessive Idling detection, Unplug detection, Towing detection, Crash detection, Auto Geofence, Manual Geofence, Trip, Limp mode|
|Sleep modes||GPS Sleep, Online Deep Sleep, Deep Sleep, Ultra Sleep|
|Configuration and firmware update||FOTA Web, FOTA, Teltonika Configurator (USB, Bluetooth)|
|SMS||Configuration, Events, Debug|
|GPRS commands||Configuration, Debug|
|Time Synchronization||GPS, NITZ, NTP|
|RS232 modes||Log mode, NMEA, LLS, TCP ASCII/Binary, LCD, RFID HID/MDF7, Garmin FMI, POS Printer|
|Ignition detection||Accelerometer, External Power Voltage, Engine RPM (OBDII dongle)|
Use Plaspy with a tracker
Set the Operator APN
- Check your tracker clock setup is set UTC-0 o GMT. (The most trackers come from the factory on UTC.)
- For most devices you should use IMEI (International Mobile Equipment Identity) number as unique identifier. However, some devices have vendor specific unique identifier, for example TK-103 devices use 11-digit identifier.
Set Up the IP and port on your tracker: (automatic detect tracker's protocol.)
Server d.plaspy.com IP 22.214.171.124 Port 8888
- Add on your Account on devices with the IMEI or unique ID.