TZone - TZ-AVL05 3G

Visit the manufacturer website

1. Tracking function

GPS+GSM double module tracking

Real time position checking

Sending positioning data periodically

Distance change alarm

Speed alarm

2. Anti-theft and alarms

SOS alarm

GPS antenna cut alarm

Power supply cut alarm

GPS no single alarm

Remote fuel and power cut

Engine, door check

Alarm of vehicle being pulled

Geo-fence alarm

Fuel level monitoring

3. Other functions

TZONE standard protocol

Store data when there is no singal

Mileage report

Low voltage alarm

G-sensor function

Anti-shifting of static GPS

OTA

4. Options

iButton

Temperature sensor 18B20

RS232 interface to connect camera, RFID reader, ect.

TF card store the data.

Specifications:

Dimension	118mm93mm31mm.
N.W for machine:	0.26KG.
External Voltage:	9V -36V.
Backup Battery:	850mAh /3.7V.
GPS Sensitivity:	-165dBm.
Exterior GSM antenna:	Receive GSM Signal better.
Exterior GPS antenna:	Receive GPS signal better.
Exterior RF antenna:	Receive RF signal better.
Power Consumption:	Active mode<100mA.
Operating Temperature Range	-20℃ to +60℃.
Humidity:	Up to 75% non-condensing.
Position Accuracy:	Within 10m for 90% (24hr static, -130dBm).
GSM Frequency:	Support Quad-band(850/900/1800/1900 Mhz).
GPS Chipset:	Super sensitivity and high accuracy.
Chipset Cold Start:	35sec.
Chipset Warm Start :	35sec.
Chipset Hot Start:	1sec.
LED:	Three LED indicators for power, GSM, GPS.
3G module:	850/900/2100mHz.
Interfaces:	3 digital inputs (2 negative inputs and 1 positive input) 2 analog detection inputs. 3 outputs. 1 RS232 port. 1 one_wire interface.

This information only is for informational purposes only, Plaspy does not have relationship with the device's manufacturer, for more information check the manufacturer's website or user manual.

Set Up TZ-AVL05 3G

Country

Operator

APN

User

Password

To set Plaspy you need to configure as follows. With the following commands through several text messages: In the example it is assumed that the device password is 000000 which is the initial data from the device and the APN are to APN_OPERATOR

Set up our operator APN
eqXEXCBGp8YFQz4kFuLmpqygXtCuNOLJFjlrFh
Define how often will transmit to our example 120 seconds
iA5RoPKbE1N9IuW8weyz
Establish the server where we will connect
uQVBboFS1zvFezLSFx11ro9R2bwPAqNMf
Activate the GPRS mode
NzGREI910SLlij

Atrás


Start Your FreeMonth		From $0.99 USD*		Pay as you go. No contract